- Locate the Mopar Toys wiring harness, probably somewhere close to where it passes by the OBD connector wiring.
- Pry open the split loom tubing and expose a few inches of the wiring harness inside. You're going to tap into these wires plus the OBD wire on the OBD connector.
The following wires from the Toys harness get tapped: | Tapped Wires | | Wire Name | Wire Location | Wire Color | Toybox 2.0 Wire | Wiring Diagram | | Ground | Toys Harness | BLACK | BLACK | | | Power | Toys Harness | RED / WHITE | RED | | | HOM Switch | Toys Harness | WHITE | GREEN | | | HOM LED | Toys Harness | YELLOW / RED | BLUE | | OBD Bus
| OBD Connector Harness
| VIOLET / YELLOW
| WHITE
| |
Cut Gray wire in Mopar Toys Harness and connect to Brown Toybox 2.0 wire. | Cut Wires | | Wire Name | Wire Location | Wire Color | Toybox 2.0 Wire | Wiring Diagram | | DAB | Toys Harness | GRAY | BROWN |
|
Read more about the Toybox 2.0 installation with Mopar Toys from SRTForums member JohnL here: http://www.srtforums.com/forums/showthread.php?t=403976 | 
